
INTUITY Messaging Solutions Release 4
MAP/5P Maintenance
585-310-186
Issue 3
October 1997
Common System Procedures
Page 3-5About Cartridge Drives and Tapes
3
Inserting the Cartridge Tape
To insert a cartridge tape, do the following:
1. Locate the tape drive on the front of the MAP/5P (Figure 3-3
).
2. Check the read/write dial to make sure that the tape is not write-protected.
The small dial on the front of the tape should be in the horizontal position.
3. Complete Steps a through c to insert the tape in the drive.
a. Press the button on the upper right corner of the drive to open the
drive door.
b. Insert the tape (Figure 3-4
).
c. Close the door to push in the tape.
Figure 3-4. Tape Insertion with a Tape Drive
NOTE:
The light on the tape drive will blink when the drive is in use. If the light is lit
and not blinking, the tape drive is idle.
Komentarze do niniejszej Instrukcji